[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[heathkit] finding signal in HR-10/DX-60 statjion

To: "heathkit-archive" <heathkit-archive@cyberventure.com>
Subject: [heathkit] finding signal in HR-10/DX-60 statjion
From: <becka@eastlink.ca>
Date: Fri, 24 Apr 2009 09:18:56 -0700
List-unsubscribe: <mailto:heathkit-Unsubscribe@cyberventure.com>
Reply-to: heathkit@cyberventure.com
Sender: heathkit-owner@cyberventure.com
Thread-index: AcnE9faYJ1z1B+WOQuSBg0jTBgWigA==

When I am operating my DX-60 and the HR-10 VFO, I can't hear my vfosignal in my
RX very well. It is so light that I can barely hear it.

Does anyone know how I can bump this up.

The signal is too strong when I key down in tune mode, If I make it reasonable
by cranking back the RF gain, the frequency is pulled along since I am modifying
the cathode voltage.

Anyone have a solution?

I guess could I "stiffen" the voltage just the way would a transistor?

Alan
VY2WU

Prev by Date: [heathkit] Need DX-60 Crystal Switch
Next by Date: [heathkit] tubes
Previous by thread: [heathkit] filament transformer
Next by thread: [heathkit] for sale
Index(es):
- Date
- Thread

Tech Resources | Related Sites | Special Features | Listserv